Avaya P330-ML-ML - Manual (Page 298)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
282 Avaya P330-ML Reference Guide
ip rip authentication mode
User level: privileged, supervisor.
Use the ip rip authentication command to specify the type of authentication
used in RIP Version 2 packets.
Use the no ip rip authentication command to restore the default value of
none.
The syntax for this command is: [no] ip rip authentication mode
[simple|none]
Example:
To specify simple authentication to be used in RIP Version 2 packets on the interface
“marketing”.
ip rip default-route-mode
User level: privileged, supervisor.
Use the ip rip default-route-mode command to enable learning of the
default route received by the RIP protocol. The default state is talk-listen.
Use the no ip rip default-route-mode command to disable learning of the
default route.
The syntax for this command is:
ip rip default-route-mode
The possible default route modes on an interface are:
simple|none The authentication type used in RIP Version 2 packets:
• simple - clear text authentication.
• none - no authentication.
Router-N(configure-if:marketing) # ip rip authentication
mode simple
talk-listen Set RIP to send and receive default route updates on
the interface.
talk-only Set RIP to send but not receive default route updates
on the interface.