Avaya P330-ML-ML - Manual (Page 100)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
86 Avaya P330-ML Reference Guide
The syntax for this command is:
set port disable /
Example:
set port dot1x initialize
User level: supervisor
Use the set port dot1x initialize command to initialize port dot1x.
The syntax for this command is:
set port dot1x initialize
Example:
set port dot1x max-req
User level: supervisor
Use the set port dot1x max-req command to set the maximal number of times
the port tries to retransmit requests to the Authenticated Station before the session is
terminated.
module Number of the switch in the stack.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are disabled.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
P330-N# set port disable 4/1
Port 4/1 disabled.
module/
port Module and port number
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
P330-1(super)# set port dot1x initialize 2/3
port 1/2 dot1x was initialized