Avaya P330-ML-ML - Manual (Page 129)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 115
Example:
set snmp timeout
User level: privileged, supervisor.
Use the set snmp timeout command to set the SNMP timeout in seconds. This
command is only used for access using the P330-ML Embedded Web Manager.
The syntax for this command is:
set snmp timeout
Example:
set snmp trap
User level: privileged, supervisor.
Use the set snmp trap command to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver.
First add the rcvr_addr and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap
set snmp trap {enable|disable}
{all|config|fault|...}
P330-N# set snmp retries 10
SNMP retries is set to 10
number Timeout in seconds
P330-N# set snmp timeout 2000
the SNMP Timeout is set to 2000
enable Activate SNMP traps
disable Deactivate SNMP traps
all (Optional) Specify all trap types
config (Optional) Specify the ConfigChange trap from the TRAP-MIB.
fault (Optional) Specify the Fault trap from the TRAP-MIB.
rcvr_addr IP address or IP alias of the system to receive SNMP traps