Avaya P330-ML-ML - Manual (Page 263)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 247
set vlan
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set vlan command to create a router Layer 2 interface.
The syntax for this command is:
set vlan name
Example:
L If you wish to enter a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
show copy status
User level: user, privileged, supervisor
Use the show copy status command to show the status of the local
configuration copy operation.
The syntax for this command is:
show copy status
Example:
vlan-id VLAN number
vlan-name VLAN name
Router-N(configure)# set vlan 2 name vlan2
Router-N> show copy status
Module #1
===========
Module : 1
Source file : .router-startup
Destination file : .router-running
Host : -
Running state : Idle
Failure display : (null)
Last warning : No-warning