Avaya P330-ML-ML - Manual (Page 290)

Chapter 3 Avaya P330-ML Layer 3 CLI Commands
274 Avaya P330-ML Reference Guide
Interface Context
L You can only access these commands in the “interface” context.
Type interface [name] at the command prompt to enter the “interface”
context if necessary.
default-metric
User level: privileged, supervisor.
Use the default metric command to set the interface RIP route metric.
Use the no default metric command to restore the default value.
The default metric is 1.
The syntax for this command is:
[no] default-metric
Example:
enable vlan commands
User level: privileged, supervisor.
Use the enable vlan commands command before configuring VLAN-oriented
parameters, such as vrrp and boorp-dhcp relay that affect all interfaces on the same
VLAN.
The syntax for this command is:
enable vlan commands
Example:
number The interface RIP route metric value. The range is 1 to 15.
Router-N(configure-if:marketing) # default metric 10
Done!
Router-N(config-if:marketing)#enable vlan commands