Avaya P330-ML-ML - Manual (Page 107)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 93
| on | proprietary}
Example:
set port level
User level: privileged, supervisor.
Use the set port level command to set the priority level of a port or range of
ports on the switching bus. Packets traveling through a port set at normal priority
should be served only after packets traveling through a port set at high priority are
served.
The syntax for this command is:
set port level / [value]
receive Indicates whether the port can receive administrative status
from a remote device.
Available only for Gigabit Ethernet modules with negotiation set to off.
send Indicate whether the local port can send administrative status to
a remote device.
Available only for Gigabit Ethernet modules with negotiation set to off.
all Send and receive (symmetric flow control).
module Number of the module.
port Number of the port on the module.
off Used with receive to turn off an attached device's ability to send
flow-control packets to a local port. Used with send to turn off
the local port's ability to send administrative status to a remote
device.
on Used with receive to require that a local port receive
administrative status from a remote device. Used with send, the
local port sends administrative status to a remote device.
P330-N# set port flowcontrol receive 5/1 on
Port 5/1 flow control receive administration status set to on
module Number of the switch.