Avaya P330-ML-ML - Manual (Page 172)

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
158 Avaya P330-ML Reference Guide
show port
User level: user, privileged, supervisor
Use the show port command to display port status.
The syntax for this command is:
show port [[/port_num]]
Example: to display the status for port 4 on switch 3
Show Port Output Fields
mod_num
(Optional) Number of the switch. If you do not specify a number, the ports
on all the switches are shown.
port_num
(Optional) Number of the port on the module (can be a vitrual LAG port
number). If you do not specify a number, all the ports on the
switch are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
P330-N>show port 3/4
Port Name Status Vlan Level Neg Dup. Spd. Type
------ --------------- --------- ---- ------ ------- ---- ---- -----------------
3/4 Gregory no link 1 0 enable half 10M 10/100BaseTx Port
Field Description
Port Switch and port number
Name Name of port
Status Status of the port (connected, no link, disabled)
Vlan VLAN ID of the port
Level Priority level of the port (0-7)
Neg The autonegotiation status of the port (enabled, disabled)
Dup Duplex setting for the port (full, half)
Speed Speed setting for the port (10Mbps, 100Mbps, 1000Mbps)
Type Port type, for example:
• 10/100Base-Tx, 1000Base-SX Port, Link Aggregation
Group of 10/100Base-T ports