GW Instek PSB-2000 Series User Manual - Manual (Page 96)

PSB-2000 Series User Manual
96
How to Connect the Units Horizontally
Steps 1. Remove the rubber feet from the side of unit
B. (Keep the removed rubber feet and screws
with care not to lose them.)
2. Fix the joint kit (PSB-007) to the side of the
unit A with the flat countersunk head screws
supplied with the kit. (Four positions)
3. Place the units as shown in the figure below
so that the prongs from the joint kit on unit
A are inserted in the holes in unit B (revealed
from under the rubber feet that were
removed).
4. Slide unit B, and fix the rear panel to the
brackets of the joint kit (PSB-004) firmly with
the screw with washer supplied with the kit.
(Two positions)
Unit A
(Viewed from above）
（Shift and screw）
Connection for Horizontal Installation
Fix PSB-007 with attached
screw at 4 positions
2 positions
Unit A
Unit B Unit B