GW Instek PSB-2000 Series User Manual - Manual (Page 126)

PSB-2000 Series User Manual
126
Sequence Mode Setting (:SEQ:MOD)
This command controls a sequence operation. It can start, stop or
pause a sequence.
Setting :SEQ:MOD
is as shown below:
0: Stops sequence operation.
1: Pause sequence operation – Waits for start.
2: Runs sequence operation (Executes sequence).
Application
example :SEQ:MOD 2
Runs the sequence.
Query :SEQ:MOD?
Inquires about the setting.
Response
example 2
Indicates that sequence operation is being executed. This
command causes an error if the sequence function is
running.
Remark None
Sequence Jump Setting (:SEQ:STEP)
This command jumps to a specified step in the sequence operation.
Setting :SEQ:STEP
The range is from 0 to 99.
This command can only be executed when a sequence is
paused.
Application
example :SEQ:STEP 2
Jumps to step 2.
Query :SEQ:STEP?
Inquires about the setting.
Response
example 2,1
Indicates that step 2 is selected and the repetition
frequency is 1(looped one time).
Remark This command causes an error if the sequence function is
running.