GW Instek PSB-2000 Series User Manual - Manual (Page 71)

OPERATION
71
Display for a slave unit in a
parallel connection
Display for a slave unit in
a series connection
Procedure 1. The master-slave settings can be accessed by
turning on the power switch while holding the
MENU key.
2. Select the operation mode for the unit with the
encoder wheel and press the ENTER / CHECK
key to confirm the setting. By default the
master-slave setting is set to OFF
Initial setting:
Single unit operation or
Master unit in a series
connection Master unit in a parallel
connection
Slave unit in a parallel
connection Slave unit in a series
connection (PSB-L only)