GW Instek PSB-2000 Series User Manual - Manual (Page 112)

PSB-2000 Series User Manual
112
Common
Model inquiry - *IDN? --- 128
ESR query - *ESR? --- 129
Event enable *ESE *ESE? --- 129
STB query - *STB? --- 129
SRQ enable *SRE *SRE? --- 129
Clear *CLS - --- 129
Reset *RST - --- 129
Completion *OPC *OPC? --- 130
Wait for
completion
*WAI - --- 130
Extension
Local
communication
:ADDR - 104 130
Remote mode :REMOTE :REMOTE? 48 131
Output Voltage Setting (:VOLT)
This command sets or inquires about the output voltage.
Setting :VOLT
Sets the output voltage of a single channel model.
:VOLT:A
Sets the output voltage of CH1.
:VOLT:B
Sets the output voltage of CH2.
The range is from 0.00 to 82.00 (PSB-L), 0.0 to
820.0 (PSH-H).
Two decimal places are valid.
Application
example :VOLT 10.10
Sets the output voltage of a single channel model to
10.10V.
Query :VOLT?
Inquires about the set output voltage of a single channel
model.
:VOLT:A?
Inquires about the set output voltage of CH1.
:VOLT:B?
Inquires about the set output voltage of CH2.
Response
example 10.10
Indicates that the set output voltage is 10.10V.
Remark When the tracking mode is on, setting CH1 will affect
CH2. Setting CH2 in the tracking mode will cause an
execution error.