GW Instek PSB-2000 Series User Manual - Manual (Page 38)

PSB-2000 Series User Manual
38
Connection with the Front Output Terminals (PSB-2400L,
2800L, 2400L2, 2800LS)
Procedure 1. Turn on the unit using the POWER switch.
2. Connect crimped lug terminals to the ends of
the load cables. Fix the load cables firmly to
eliminate loose connections from the front
output terminals and load cables.
3. If current is output through the rear output
terminals, cover the front output terminals
with the protective caps for safety.
Fig. Connection
with Front Output
Terminals
(Good) (Bad)
CAUTION  The power supply unit may output a
maximum of 40A through the front output
terminals. Do not use pin plugs or banana
plugs for outputting large current in order to
avoid overheating due to contact resistance.
Use lug terminals that meet the output current
rating and connect them firmly to the front
output terminals.
 For safety, NEVER output power through both
the front and rear output terminals.