GW Instek PSB-2000 Series User Manual - Manual (Page 56)

PSB-2000 Series User Manual
56
Hi-Ω Off Hi-Ω On
3. Press the ENTER / CHECK key to confirm the
setting.
The Hi-Ω LED in the center of the panel turns
on.
○
OFF TIMER
○ DELAY
● Hi-Ω
4. Next, set the time limit for when the bleeder
circuits are turned back on with the encoder
wheel.
Setting range: 5~30 minutes.
Setting resolution: 5 minute steps.
Press the ENTER / CHECK key to confirm the
setting.
Example: Timer set for 20 minutes.
5. Press the ESC / DISP key to quit the setting
mode and return to normal operation.