GW Instek PSB-2000 Series User Manual - Manual (Page 105)

EXTERNAL CONTROL
105
Procedure 1. Turn on the unit while holding the A key to
set the System Address and/or Personal
Computer Address. The model name and
version data are displayed first, and then the
interface type is displayed. After this, the
System Address may be set
1
. ―Sy.Ad‖ is
displayed on the Voltage LED, and the
address is displayed on the Current LED.
Rotate the encoder to select the System
Address, and press the ENTER /
CHECK key to
confirm.
A unit whose System Address is set other than
1 will return to normal operation.
1
Keep the A key depressed until ―Sy.Ad‖ is
displayed.
System Address 1
2. If the System Address is set to 1, ―PC.Ad‖ is
displayed on the Voltage LED, indicating that
a Personal Computer Address can be set.
Rotate the encoder to select the Personal
Computer Address, and press the ENTER /
CHECK key to confirm.
The unit will return to normal operation.
Personal Computer Address 4