GW Instek PSB-2000 Series User Manual - Manual (Page 95)

OTHER FUNCTIONS
95
How to Connect the Units Vertically
Steps 1. Remove the rubber feet from the bottom of
unit A. (Keep the removed rubber feet and
screws with care not to lose them.)
2. Fix the joint kit (PSB-007) to the top panel of
unit B with the flat countersunk head screws
supplied with the kit. (Four positions)
3. Place the units as shown in the figure below
so that the prongs from the PSB-007 joint kit
on the unit B are inserted in the holes in unit
A (revealed from under the rubber feet that
were removed).
4. Slide unit A and fix the rear panel to the
brackets on the joint kit (PSB-007) firmly
with the screw with washer supplied with
the kit. (Two positions)
Unit A
Unit B
(Viewed from side）
Unit A
Unit B
（Shift and screw）
Connection for Vertical Installation
Fix PSB-007 with
attached screw at 4
positions
2 positions