GW Instek PSB-2000 Series User Manual - Manual (Page 32)

PSB-2000 Series User Manual
32
O
PERATION
This chapter describes the start up procedures
and the preparation that is necessary before
operating the DC power supply.
Connecting the AC Power Cable
Introduction  Make sure that the power source is shut off.
 Use the AC power cable supplied with the
product.
 Plug the connector of the AC power cable into
the AC INPUT receptacle on the rear panel.
Connecting the Load to the Output
Terminals
Introduction Use cables with a rated voltage that exceeds the
grounding voltage (500V) for the load.
The front output terminals and rear output
terminals are electrically connected internally.
When the front output terminals are used, the rear
output terminals are also active. Put the protective
covers supplied with the product on the rear
output terminals to avoid electrocution.
CAUTION Make sure that the load is only connected when
the POWER switch is off.
To connect a load, use cables that have a large
enough current capacity for the rated output and
current in order to prevent a fire.
The current capacity of the cables should be higher