GW Instek PSB-2000 Series User Manual - Manual (Page 107)

EXTERNAL CONTROL
107
Using the Interface Boards
Using the GPIB interface
Description  All GPIB operations have been tested using a
NATIONAL INSTRUMENTS GPIB controller
and sample programs. All interface cards
conforming to the IEEE488 standard should be
compatible with the PSB-001 interface board.
However, compatibility cannot be assured.
 The PSB-001 accepts the following delimiters:
LF (0×0A), EOI, and LF (0×0A) + EOI. It sends a
response using LF (0×0A) + EOI only.
 When using the local bus through GPIB, control
must be returned to the master unit after
transferring commands to the slave units
2
.
Unless control has been returned to the master
unit, the GPIB controller on the PC may fail to
recognize the interface board properly.
 The Personal Computer Address may be set
only when the System Address is set to 1. The
Personal Computer Address is used to represent
the GPIB address.
2
Send ADDR1.