GW Instek PSB-2000 Series User Manual - Manual (Page 127)

EXTERNAL CONTROL
127
Sequence Start Step Setting (:SEQ:START)
This command specifies which step to start from when running a
sequence.
Setting :SEQ:START
The range is from 0 to 99.
Application
example :SEQ:START2
Sets the sequence to start from step no. 2.
Query :SEQ:START?
Inquires about the setting.
Response
example 2
Indicates that the sequence starts from step 2.
Remark None
Sequencer End Step Setting (:SEQ:END)
This command specifies which step to end the sequence on.
Setting :SEQ:END
The range is from 0 to 99.
Application
example :SEQ:END2
Sets the sequence to end at step no. 2.
Query :SEQ:END?
Inquires about the setting.
Response
example 2
Indicates that the sequence ends at step no. 2.
Remark None
Sequence Repetition Frequency Setting (:SEQ:CYCL)
This command specifies the number of times the sequence is
looped(repetition frequence).
Setting :SEQ:YCL
The range is from 0 to 999.
When set to 0, the sequence is repeated endlessly (infinite
loops).
Application
example :SEQ:CYCL 2
Sets the sequence to loop 2 times.
Query :SEQ:CYCL?
Inquires about the setting.
Response
example 2
Indicates that the sequence is looped twice.