Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 78)

Serial Data Debug Solutions
78 919586 RevA

Ask your local LeCroy representative for more information about any Serial Data Debug Solution Protocols
or Toolkits using the Contact LeCroy for Support (on page 199) topic.
FlexRaybus Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).
F LEX R AYBUS B ASIC AND L EVELS R IGHT -H AND D IALOGS
Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.
Touch the corresponding Setup... button for your decode. The Decode Setup... along with corresponding right-
hand dialogs are shown.
FlexRaybus Basic Right-Hand Dialog
The Basic right-hand dialog provides detailed controls and setup conditions as follows:

Bitrate - Adjust this bitrate value to match the one on the bus to which you are connected. This bit rate
selection is dynamically linked to the decoding bitrate (they are always the same value). Use the arrows
to move through standard bitrates (2.5, 5.0 or 10.0 Mb/s) and make a selection. Or, touch the number
twice (with a finger, or using a mouse) and open the pop-up keypad to enter the value directly.

Channel - Select the appropriate channel for decoding (based on whether it's coming from Channel A or
Channel B of the FlexRay bus). The channel selection drives the CRC computation.
Note: Decode still works when the wrong channel is selected. It results in CRC errors being shown on
the decode. Fix it by switching the channel selection.
FlexRaybus Levels Right-Hand Dialog
The Levels right-hand dialog provides detailed controls and setup conditions as follows: