Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 128)

Serial Data Debug Solutions
128 919586 RevA

RTI - Re-Transmission Indicator

CRC - Coherency Redundancy Check

EoF - End of Frame
Customizing WordName and Comment Definitions
Definitions for both WordName and Comment appear as table columns, trace descriptor labels, and search
parameters for DigRF v4 decoded waveforms.
Use the following steps to create your own customizations to WordName and Comment values.
1. Minimize the oscilloscope application by selecting File → Minimize on the menu bar.
2. Open File Explorer and access the DigRFv4_B10I.xml file on your oscilloscope located in the
D:\Applications\DigRF\ folder.
3. Open the DigRFv4_B10I.xml file in your preferred text or XML editor. Search for the hexadecimal value
(shown in the XML code as a value for the ID_VAL property) for mapping to your custom value. In the
case of our example, we'll look for 0x96.
4. Now, modify the corresponding TITLE property to your custom value.
5. After saving and closing the DigRFv4_B10I.xml file, Exit the oscilloscope application by selecting File →
Exit. Re-launch the oscilloscope application by double-clicking the Start DSO shortcut on the desktop.
6. Notice your customizations appearing on WordName and Comment values for table columns, trace
descriptor labels, and search parameters.
Using the MIPI D-PHY (CSI-2/DSI) Option
Using the MIPI D-PHY Decode Option Overview
The MIPI D-PHY decode option defines lowest layers of high-speed, source-synchronous interfaces based on the
MIPI Alliance specification.
The D-PHY option has separate decoder selections available for MIPI D-PHY, MIPI CSI-2, and MIPI DSI. The CSI-2
and DSI signals define the application layer of camera and display protocols, respectively (based on the D-PHY
physical layer).
Note: Ask your local LeCroy representative for more information about any Serial Data Debug Solution
Protocols or Toolkits using the Contact LeCroy for Support (on page 199) topic.
MIPI D-PHY Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).