Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 145)

Operator's Manual
919586 RevA 145
Using the MIPI M-PHY
Using the MIPI M-PHY Decode Option Overview
The MIPI M-PHY decode option defines the next-generation lowest physical layers of high-speed, source-
synchronous interfaces based on the MIPI Alliance specification.
Note: Ask your local LeCroy representative for more information about any Serial Data Debug Solution
Protocols or Toolkits using the Contact LeCroy for Support (on page 199) topic.
MIPI M-PHY Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).
MIPI M-PHY S OURCE AND C LOCK C ONTROLS , B ASIC , AND L EVELS R IGHT -H AND D IALOGS
Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.
Touch the corresponding Setup... button for your decode. The Decode Setup... along with a corresponding right-
hand dialog is shown.
Decode Setup and MPHY Decode dialogs include the following controls:
M-PHY Source and Clock Controls
Depending on your probing selection on the right-hand dialog, corresponding source controls are provided for
Ddiff (differential clock trace), or Dp (Data positive) and Dn (Data negative).