Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 22)

Serial Data Debug Solutions
22 919586 RevA
PLEASE NOTE THE FOLLOWING:

Search capabilities differ by protocol. For instance, SPI has no Address, so there is no capability to Search
by Address in
SPI , while there is when searching under the I 2 C protocol.

Use the Search Options buttons to define the type of Search you want, enter a value in Hexadecimal
format, and use the left and right arrows to move your way from one message to the next.

When using search on a multi-data-lane protocol (PCIe), Z5 - Z8 zoom traces are used. Otherwise, single-
data-lane protocols use Z1 - Z4 zoom traces (based on the decoder assignment).
Using The T Supported Protocol Toolsets
When you acquire a LeCroy Serial Data Debug Solution equipped with a Serial Trigger, you access the specific
protocol trigger using one of the following methods:

Touch the Trigger Descriptor Box in the lower right hand corner of the oscilloscope display.
OR

Touch Trigger → Trigger Setup from the Menu Bar.

Some oscilloscope models may also have a Decode front panel button which shows the main Serial
Decode dialog when pressed.
Now, touch the Serial button on the Type section of the Trigger dialog.
Touch the Protocol field on the Standard section of the Trigger dialog and select your protocol from the choices
shown.
The focus then selects one tab to the right showing the selected Trigger Condition dialog reflecting the selected
protocol standard just selected.