Index, Operator's manual – Teledyne LeCroy Serial Data Debug Solutions User Manual
Page 201
Operator's Manual
919586 RevA
201
Index
3
3b/4b, 50
5
5. Error Sub-Type and Right-Hand Dialog, 116
5. Timing Sub-Types and Right-Hand Dialogs, 116
5. Transfer Sub-Type Right-Hand Dialogs, 108
5. Word Sub-Type Right-Hand Dialogs, 115
5b/6b, 50
8
8b/10b Decode Search, 52
8b/10b Decode Setup Detail, 45
A
Accessing and Using Supported Protocol Toolsets
Overview, 12
Accessing and Using The Graphing Tools for
Supported Protocols, 32
Accessing and Using The PROTObus MAG Supported
Protocol Toolset, 23
Accessing The D and TD Supported Protocol
Toolsets, 13
Additional Controls, 152
ARINC 429 Decode Search, 102
ARINC 429 Decode Setup Detail, 97
ARINC 429 Decode Table Column Details, 101
ARINC 429 Decode Trace Annotations, 100
Assumptions, 9
AudioBus Decode Setup Detail, 87
AudioBus Measure/Graph Setup Detail, 96
AudioBus Trigger Setup Detail, 92
Automotive and Industrial Protocols Overview, 68
B
BC-RT (Rcv) Sub-Type and Right-Hand Dialogs, 108
BC-RT(S) (B'cast) Sub-Type and Right-Hand Dialogs,
113
Bit Rate, 144, 153
C
CANbus Decode Setup Detail, 69
CANbus Trigger Setup Detail, 70
Capturing Long Pre-Trigger Times, 37
Category and Measure Combinations for HS Dphy1 -
12 Dialogs, 139
Category and Measure Combinations for LP Dphy1 -
12 Dialogs, 137
Characterization Using Cursors, 34
Characterization Using Measurement Parameters,
34
Characterizing Embedded Controller Performance
Using Standard Oscilloscope Tools Overview, 32
Command Sub-Type and Right-Hand Dialog, 115
Compatibility, 10
Control Symbols, 51
Creating a CANbus Trigger Condition, 70
Creating a FlexRaybus Trigger Condition, 79
Creating a LINbus Trigger Condition, 74
Creating a MIL-STD-1553 Trigger Condition, 106
Creating a SATA Trigger Condition, 179
Creating a SPIbus Trigger Condition, 60
Creating a USB2 Trigger Condition, 187
Creating an I2Cbus Trigger Condition, 55
Customizing WordName and Comment Definitions,
128
D
Data Sub-Type and Right-Hand Dialog, 115, 117
Decode Toolset Features and Controls Overview, 18
Dialog Area, 196