Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 21)

Operator's Manual
919586 RevA 21

Checkboxes - Touch items to check the box and include them as table columns for a particular protocol.

BitRate Tolerance - Some protocols have a Bit Rate Tolerance setting. This can be set to any value from
0.01% to 10%. If the bit rate is outside the tolerance range set, then the calculated bit rate appears in red
text on the table.
Protocols with a wide variance of bit rates, such as I 2 C (which often has clock stretching) do not have this
feature.

Default - Press the Default button to reapply standard settings for a particular protocol.
S EARCHING FOR M ESSAGES
There are several ways to search for specific messages. The following are all valid ways to search messages.

Touch the decoded waveform. A pop-up dialog is shown where you can select Decode Search as follows:
OR

Touch the Search button in the Serial Decode Summary dialog box or the Decode Setup dialog box.
OR

Go to Math → Zoom Setup... from the Menu Bar to turn a Zoom ON, define its source, and search
directly.
Any of the aforementioned methods show the Zoom dialog box and a corresponding Search dialog box on the
right side.