Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 120)

Serial Data Debug Solutions
120 919586 RevA

Hysteresis (V) - Provide a desired voltage level for the Hysteresis.
Setup

Speed-mode - Choose from Low (6.5Mbps), Medium (26Mbps), and High (320Mbps) values.

Start Pattern - Provide a desired value using the Hexadecimal Virtual Keypad, if desired.
DigRF 3G Decode Trace Annotations
Like all trace annotations, DigRF 3G Decode annotations are rectangular shadings used to highlight messages on
decoded waveforms for easy viewing.
Tip: Data packets (or messages) on properly decoded protocol signals can be viewed using Serial Decode Trace
Annotations (on page 18), the Protocol Results Table (on page 19), and/or by Searching for Messages (on
page 21) (Types and Subtypes). Using these tools together provides fast insight to your data. See Serial Decode
Trace Annotations (on page 18) for more information.
Messages shown as annotations, table columns, and search types for most protocols are classified into Frames,
Errors, Unknown, or Grouped Primitives specific to the protocol. Sub Types then further classify each main
message type into more protocol-specific messages.
Decode annotations unique to DigRF 3G include the following (some annotations are not shown in the screen-
shot):
DigRF 3G Decode Annotations

Sync

Payload Size

LCTS

CTS/RTI

Word Name

Comment

Payload

I Data

Q Data
Note: Specifications are subject to change without notice.