Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 40)

Serial Data Debug Solutions
40 919586 RevA
When you’ve acquired the set number of segments, the trigger STOPS and a display similar to the
following is shown (this is a 50 segment acquisition in Mosaic display mode).

You can display an individual segment separately from the main channel display by selecting Math →
Math Setup... from the menu bar. Choose a math trace to define as a Segment (in this case, F1 is defined
as a Segment of C2). Use the channel that your serial data was acquired on (in this case Channel 2) as a
Source.