Burkert Type 8717 - Manual (Page 25)

25
Serial Communication
command number
command name
Device types 0x98
extSetpointwithoutanswer
0xee
request
Command
0x92
Byte count 5
data 1 byte
0
Set-point value settings, internal
1 Set-point value settings, external
4 bytes
1 – 4
Set-point value [%] (float) 1)
response
Command
-
Byte count -
Status -
data -
Description
Available as of firmware version A.00.51.06.
determines the set-point value settings and describes the external set-point value as a percentage:
Internal = analog - the set-point value settings is assigned by the analog
set-point value signal that is created
External = digital via serial interface
do not use this command if you are using a bus device (PROFIBUS, deviceNet, etc.). The digital set-point
value settings via the serial interface has a higher priority.
No response is sent for this command.
1) First byte transferred: MSB
english
MFC Family