. switching.between.the.operating.levels, . automatic.operating.state, Meaning of the keys – Burkert Type 8693 User Manual
Page 88: Switching between the operating levels, Automatic operating state

88
Start-up and operation of the
position controller Type 8692
21.2. switching between the operating levels
process operating level
► configuration level
Both in the MANUAL and AUTOMATIC operating state you switch to the configuration level by pressing the left
selection key (MENU) for approx. 3 seconds. During these 3 seconds 2 bars converge on the display (Countdown).
At the Configuration level the operating parameters can be input or changed, auxiliary functions supplemented or
the automatic adjustment (
X.TUNE) of the controller started.
A precise description of the individual functions can be found in the chapters entitled "20. 4 Specifying
the basic settings" and in "22. Configuring the auxiliary functions".
configuration level
► process operating level
Press the left selection key (EXIT) to switch from the Configuration level to the Process operating level. In doing so,
the operating state which was selected before the switchover (AUTOMATIC or MANUAL) is set.
21.3. auTOmaTic operating state
Bar running from left to right along the upper edge of the display.
Normal control mode is implemented and monitored in AUTOMATIC operating state.
21.3.1. meaning of the keys
key
configuration
description
Left selection key
MENU
Switch to the Configuration level (press for approx. 3 s)
Right selection key
MANU
Switch between the AUTOMATIC (AUTO) or MANUAL (MANU)
operating modes
Up arrow key
INPUT
POS
CMD
TEMP
Switch between the individual displays
Down arrow key
CMD
TEMP
INPUT
POS
Table 26:
AUTOMATIC operating state; Meaning of the keys
english
Type 8692, 8693