Burkert Type 8693 - Manual (Page 37)

37
Control and display elements,
operating modes
key
configuration
(indicated in the lower bar)
operating status / operating level
Up / down arrow key Change the display
(e.g.
POS-CMD-TEMP-...)
AUTOMATIC / Operate process
OPN - CLS (OPEN - CLOSE)
manual opening and closing of the actuator MANUAL / Operate process
Scroll up and down the menus AUTOMATIC or MANUAL /
Parameterization or Configuration
+ and -
increase or reduce numerical values AUTOMATIC or MANUAL /
Parameterization or Configuration
+ and ←→
adjust numerical values by individual digits AUTOMATIC or MANUAL /
Parameterization or Configuration
Left selection key Switch to the Parameterization level (MENU)
Note:
the key must be pressed for approx. 3 s
(Countdown: 2 bars converge on the display
panel)
AUTOMATIC or MANUAL /
Operate process
EXIT (BACK)
Operate process on the operating level AUTOMATIC or MANUAL /
Parameterization
EXIT (BACK)
from a menu option on the operating level
Parameterization or Configuration AUTOMATIC or MANUAL /
Parameterization or Configuration
ESC
Leave a menu AUTOMATIC or MANUAL /
Parameterization or Configuration
STOP
End a sequence AUTOMATIC or MANUAL /
Parameterization or Configuration
Right selection key Switch between AUTOMATIC and MANUAL
mode Operate process
HOLD - CONT
Hold / continue of the graphic display of
process actual value and set-point value
Operate process
Select, activate or deactivate a menu option
(ENTER, SELEC, OK, INPUT) AUTOMATIC or MANUAL /
Parameterization or Configuration
EXIT (BACK)
from a menu option on the operating level
Parameterization or Configuration AUTOMATIC or MANUAL /
Parameterization or Configuration
RUN
Start a sequence AUTOMATIC or MANUAL /
Parameterization or Configuration
STOP
End a sequence AUTOMATIC or MANUAL /
Parameterization or Configuration
Table 9: Configuration of the keys
english
Type 8692, 8693