Burkert Type 8693 - Manual (Page 163)

163
Start-up and operation of the
position controller Type 8693
OUT ANALOG.-.Configuration.of.the.analogue.output
Only for the versions:
• one analogue output
• one analogue output and two binary outputs
The feedback of the current position ( POS), the position set-point value (CMD), the process actual value (PV) or
the process set-point value ( SP) can be transmitted to the control centre via the analogue output.
SELEC
Out POS
EXIT
OUT type
Output of the current position OUT ANALOG
ENTER
Out CMD
Out PV
Out SP
ENTER
Output of the position set-point value
Output of the process actual value
Output of the process set-point value
SELEC
4 - 20 mA
Selection of
the unit signal
EXIT
0 - 20 mA
0 - 10 V
0 - 5 V
Figure 103: Operating structure OUTPUT-ANALOGUE-8693
Changed values are not transferred into the memory (EEPROM) until the main menu (MAIN) is left.
english
Type 8692, 8693