Burkert Type 8693 User Manual
Page 164

164
Start-up and operation of the
position controller Type 8693
OUT BIN1.-.Configuration.of.the.binary.output.1
OUT BIN2.-.Configuration.of.the.binary.output.2
Only for the versions:
• one analogue output and two binary outputs
• two binary outputs
The following description applies to both binary outputs
OUT BIN 1 and OUT BIN 2.
The binary outputs 1 and 2 can be used for one of the following outputs:
• Alarm output for excessively large control deviations of the position controller
• for the output of the current position with respect to a specified limit position (> or <)
• for the output: actuator in safety position
• for the output: sensor break process set-point value
52)
• for the output: sensor break process actual value
52)
• for the output: operating state MANUAL / AUTOMATIC.
52)
Only possible if signal level fault detection activated (see chapter entitled “25.4. SIG-ERROR Configuration of
signal level fault detection”)
english
Type 8692, 8693