Input signals from the control centre (e.g. plc) – Burkert Type 8693 User Manual
Page 68
68
Installation
18.2. Terminal board of the positioner with screw
terminals and switches
Screw terminals
Switch
1
10
12
13
14
11
8
9
1
2
3
4
5
6
7
Figure 32:
Terminal board with screw terminals and switch
Procedere:
→
The connection terminals can be accessed by removing the cover from the cable glands. To do this, unscrew
the 4 screws.
→
Connect the positioner accordingly:
type 8692:
see chapter entitled “18.3 Terminal assignment for cable gland - position controller Type 8692”
type 8693:
see chapter entitled “18.4 Terminal assignment for cable gland - process controller Type 8693”
18.3. Terminal assignment for cable gland - position
controller Type 8692
18.3.1. input signals from the control centre (e.g. plc)
Terminal Configuration
External.circuit
11
10
Set-point value +
Set-point value GND
11
10
GND
+ (0/4 – 20 mA or 0 – 5 / 10 V)
12
13
Binary input + (optional only)
Binary input GND (optional only)
12
13
GND
+
0 – 5 V (log. 0)
10 – 30 V (log. 1)
Table 20:
Configuration screw terminals - input signals from the control centre
english
Type 8692, 8693