Setting the input signal (standard signal) – Burkert Type 8693 User Manual
Page 73
73
Installation
MENU
INPUT
CMD
MANU
POS
%
XXX
Up arrow key
Description of
configuration of
the keys
Left selection key
Right selection key
Display
Down arrow key
Figure 34:
Description of the control module
An overview of the operating structure of the basic settings can be found in the chapter entitled “19.3.3
Overview of operating structure – Initial start-up” .
19.3.1. setting the input signal (standard signal):
→
Using the arrow keys, mark the
INPUT menu option in the main menu and then press the right selection key
(ENTER) to enter the
INPUT submenu.
→
Using the arrow keys, mark the input signal (4 - 20 mA, 0 - 20 mA, ...).
→
Press the right selection key (SELEC) to select the input signal (dot is marked).
→
To leave the submenu, press the left selection button (EXIT).
→
To leave the main menu, press the left selection button (EXIT) again.
You have to leave the main menu by pressing the left selection button (EXIT) before the modified data is
saved in the memory (EEPROM). During the save process the message “
SAVE EEPROM” is indicated on
the display.
english
Type 8692, 8693