Setting up the process image (mapping) – Burkert Type 8693 User Manual
Page 212

212
DeviceNet
47.1. setting up the process image (mapping)
The
AUTOMAP function is used to assign the input data of the devices specified in the scan list to the process
image of the DeviceNet master/scanner.
Our example of the assignment is indicated in “Figure 130: ”.
For example the input process values of the positioner with address 3 are assigned to the internal addresses of the
scanner as follows:
Actual position
I:1.1
Nominal position I:1.2
Error
I:1.3
Therefore, if the actual position of the positioner with address 3 is to be read from a control program, this is done by
accessing I:1.1.
Figure 130: Screenshot - DeviceNet - Figure 5
english
Type 8692, 8693
This manual is related to the following products: