ZyXEL Communications 200 Series - Manual (Page 97)

Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
97
Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”)
characters. Proceed hexadecimal characters with “0x”.
Figure 36 VPN Express Wizard: Step 3
The following table describes the labels in this screen.
4.8.1 VPN Express Wizard - Policy Setting
The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP
addresses must be static.
Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also
specify a subnet. This must match the remote IP address configured on the peer IPSec device.
Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device.
You can also specify a subnet. This must match the local IP address configured on the peer
IPSec device.
Table 16 VPN Express Wizard: Step 3
LABEL DESCRIPTION
Local Policy
(IP/Mask) Type a static local IP address that corresponds to the remote IPSec router's
configured remote IP address (the remote IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind your ZyWALL.
Remote Policy
(IP/Mask) Type a static local IP address that corresponds to the remote IPSec router's
configured local IP address (the local IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind the remote gateway.
Next Click Next to continue.