ZyXEL Communications 200 Series - Manual (Page 86)

Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
86
Figure 25 PPTP Encapsulation: Auto
The following table describes the labels in this screen.
Table 11 PPTP Encapsulation: Auto
LABEL DESCRIPTION
ISP Parameters
Encapsulation This displays the type of Internet connection you are configuring.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -
_
@$./ characters, and it can be up to 31 characters long.
Password Type the password associated with the user name above. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
Retype to Confirm Type your password again for confirmation.
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically
disconnects from the PPTP server.
PPTP
Configuration
Base Interface This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
Base IP Address Type the (static) IP address assigned to you by your ISP.
IP Subnet Mask Type the subnet mask assigned to you by your ISP (if given).
Server IP Type the IP address of the PPTP server.
Connection ID Enter the connection ID or connection name in this field. It must follow the "c:id"
and "n:name" format. For example, C:12 or N:My ISP.
This field is optional and depends on the requirements of your DSL modem.
You can use alphanumeric and -_
: characters, and it can be up to 31 characters
long.
WAN IP Address
Assignments
WAN Interface This displays the identity of the interface you configure to connect with your ISP.