ZyXEL Communications 200 Series - Manual (Page 246)

Chapter 10 Interface
ZyWALL USG 100/200 Series User’s Guide
246
If you set the filter to deny access and add the MAC address of a connected device, the
ZyWALL drops the device’s connection immediately. However, if you set the filter to allow
only the specified MAC addresses, the ZyWALL does not immediately disconnect all
connected wireless clients.
To change your ZyWALL’s MAC filter settings, click Network > Interface > WLAN >
MAC Filter > Add (or Edit). The screen appears as shown when you click Add. You cannot
edit the MAC address if you click Edit.
Figure 173 Network > Interface > WLAN > MAC Filter > Add
The following table describes the labels in this menu.
10.11 WLAN Interface Station Monitor Screen
The station monitor displays the connection status of the wireless clients connected to (or
trying to connect to) a IEEE 802.11b/g card installed in the ZyWALL. To open the station
monitor, click Network > Interface > WLAN > Station Monitor. The screen appears as
shown.
Figure 174 Network > Interface > WLAN > Station Monitor
The following table describes the labels in this menu.
Table 72 Network > Interface > WLAN > MAC Filter
LABEL DESCRIPTION
MAC
Address Enter the MAC address (in XX:XX:XX:XX:XX:XX format) of the wireless station that is to
be allowed or denied access to the ZyWALL.
Description Enter a descriptive name for the MAC address entry.
OK Click OK to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
Table 73 Network > Interface > WLAN > Station Monitor
LABEL DESCRIPTION
Extension
Slot Select the location where the IEEE 802.11b/g is located.
Refresh Click this button to update the information in the screen.
# This is the index number of the MAC address.