ZyXEL Communications 200 Series - Manual (Page 81)

Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
81
4.3.4 PPPoE: Auto IP Address Assignment
If you select Auto as the IP Address Assignment in the previous screen, the following screen
displays after you click Next.
Figure 21 PPPoE Encapsulation: Auto
The following table describes the labels in this screen.
The ZyWALL applies the configuration settings.
Table 9 PPPoE Encapsulation: Auto
LABEL DESCRIPTION
ISP Parameters
Encapsulation This displays the type of Internet connection you are configuring.
Service Name Type the PPPoE service name given to you by your ISP. PPPoE uses a service
name to identify and reach the PPPoE server. You can use alphanumeric and -
_
@$./ characters, and it can be up to 64 characters long.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -
_
@$./ characters, and it can be up to 31 characters long.
Password Type the password associated with the user name above. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
Retype to
Confirm
Type your password again for confirmation.
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically disconnects
from the PPPoE server. The default time is 100 seconds.
WAN IP Address
Assignments
WAN Interface This displays the identity of the interface you configure to connect with your ISP.
Zone This field displays to which security zone this interface and Internet connection will
belong.
IP Address The ISP will assign your WAN IP address automatically
Next Click Next to continue.