12 vantage cnm, 1 configuring vantage cnm, Figure 524 system > dial-in mgmt – ZyXEL Communications 200 Series User Manual
Page 700: Table 245 system > dial-in mgmt
Chapter 43 System
ZyWALL USG 100/200 Series User’s Guide
700
Figure 524 System > Dial-in Mgmt
The following table describes the labels in this screen.
43.12 Vantage CNM
Vantage CNM (Centralized Network Management) is a browser-based global management
solution that allows an administrator from any location to easily configure, manage, monitor
and troubleshoot ZyXEL devices located worldwide. See the Vantage CNM User's Guide for
details.
If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not
do any configurations directly to the ZyWALL (using either the web configurator or
commands) without notifying the Vantage CNM administrator.
43.12.1 Configuring Vantage CNM
Vantage CNM is disabled on the device by default. Click System > Vantage CNM to
configure your device’s Vantage CNM settings.
Table 245 System > Dial-in Mgmt
LABEL
DESCRIPTION
Dial-in Server
Properties
Click Advanced to display more configuration fields and edit the details of your
dial-in management setup. Click Basic to display fewer fields.
Enable
Select this check box to turn on dial-in management.
Description
Enter some information about this connection.
Mute
Select this check box to stop the external serial modem from making audible
sounds during a dial-in management session.
Answer Rings
Set how many times the ZyWALL lets the incoming dial-in management session
ring before processing it.
Port Speed
Use the drop-down list box to select the speed of the connection between the
ZyWALL’s auxiliary port and the external modem. Available speeds are: 9600,
19200, 38400, 57600, or 115200 bps.
Initial String
Type the AT command string that the ZyWALL returns to the external serial
modem connected to the ZyWALL’s auxiliary port during connection initialization.
Note: Consult the manual of your external serial modem
connected to your ZyWALL’s auxiliary port for specific AT
commands.
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to begin configuring this screen afresh.