1 policy route edit screen, Figure 195 network > routing > policy route > edit, Table 90 network > routing > policy route > edit – ZyXEL Communications 200 Series User Manual
Page 281
Chapter 12 Policy and Static Routes
ZyWALL USG 100/200 Series User’s Guide
281
12.2.1 Policy Route Edit Screen
Click Network > Routing to open the Policy Route screen. Then click
the Add or Edit icon
to open the Policy Route Edit screen. Use this screen to configure or edit a policy route.
See
NAT Loopback Example on page 317
for an example of NAT loopback.
Figure 195 Network > Routing > Policy Route > Edit
The following table describes the labels in this screen.
Table 90 Network > Routing > Policy Route > Edit
LABEL
DESCRIPTION
Configuration
Enable
Select this to activate the policy.
Description
Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User
Select a user name or user group from which the packets are sent. Select Create
Object to configure a new user account (see
for
details).
Incoming
Interface
Click Change... to select an interface or VPN tunnel through which the incoming
packets are received.
Source Address
Select a source IP address object or select Create Object to configure a new one.
Destination
Address
Select a destination IP address object or select Create Object to configure a new
one. If the next hop is a dynamic VPN tunnel and you enable Auto Destination
Address, the ZyWALL uses the local network of the peer router that initiated an
incoming dynamic IPSec tunnel as the destination address of the policy instead of
your configuration here.