ZyXEL Communications 200 Series - Manual (Page 603)

Chapter 35 User/Group
ZyWALL USG 100/200 Series User’s Guide
603
The following table describes the labels in this screen.
35.4.2 User Aware Login Example
Access users cannot use the Web configurator to browse the configuration of the ZyWALL.
Instead, when access users log in to the ZyWALL (forced in the screen as shown in
Figure 445
on page 600 or otherwise), the following screen appears.
Figure 447 Web Configurator for Non-Admin Users
Table 197 Object > User/Group > Setting > Add/Edit
LABEL DESCRIPTION
Enable Select this if you want this condition to be active.
Description Enter a description for this condition. It can be up to 60 printable ASCII characters
long.
Authentication Select whether users must log in (force) or whether users do not have to log in
(skip) when this condition is checked and satisfied.
Source Address Select a source IP address object or select Create Object to configure a new one.
Select any if this condition applies to traffic from all source addresses.
Destination
Address Select the destination address of traffic to which this condition applies or select
Create Object to configure a new one. Select any if this condition applies to traffic
from all destination addresses.
Schedule Select the schedule object that specifies when this condition applies or select
Create Object to configure a new one (see
Chapter 38 on page 619 for details).
Select none if this condition always applies.
OK Select this to save your changes and return to the previous screen.
Cancel Select this to return to the previous screen without saving any changes.