beautypg.com

Which parameters are modulatable, 1 which parameters are modulatable – Native Instruments MASCHINE MIKRO MK3 Groove Production Studio (Black) User Manual

Page 444

background image

Modulation

Automation

Source of control

Internal (e.g., changes

recorded via Auto-write)

External (e.g., an external

MIDI sequencer or an
automation track in your host)

Duration of the change

Temporary (until the end of
the Clip)

Permanent

Target parameters

At the Sound and Group

levels only (see below)

At all levels (Sound, Group,

and Master)

Nature of the change

(continuous parameters only)

Relative (defines a deviation

to the non-modulated value)

Absolute (defines a new value

regardless of the non-

automated value)

This section describes how to use modulation in MASCHINE — for more information on using auto-
mation, please refer to section

12.2.3, Controlling Parameters via MIDI and Host Automation

.

Please note that modulation and automation are not mutually exclusive: You can modulate a
parameter in MASCHINE

and

automate it (e.g., from your host) simultaneously! As a result,

the parameter value will deviate (according to the recorded modulation) from its moving value
defined by the automation.

Example: Let’s assume that you have recorded some modulation for the

Cutoff

parameter of a Filter

Plug-in in order to create a filter sweep. Since modulation is defined relative to the non-modulated
value, by manually adjusting the

Cutoff

parameter you can shift the entire sweep across frequen-

cies. By assigning this

Cutoff

parameter to a MIDI control or an automation ID (see section

12.2.3, Controlling Parameters via MIDI and Host Automation

to know how to do this) you can cre-

ate a filter sweep that automatically moves across frequencies!

11.5.1 Which Parameters Are Modulatable?

All the modulatable parameters are found in Plug-ins or Channel properties (e.g., you cannot

modulate the Pattern Length or the Step Grid resolution). This means that all modulatable pa-
rameters are found in a Parameter page of the Control area (when the software is in Arrange
view).

Working with Patterns

Recording and Editing Modulation

MASCHINE MIKRO - Manual - 444