Native Instruments MASCHINE MIKRO MK3 Groove Production Studio (Black) - Manual (Page 241)

General Notes on Scales and Chords
▪ The Scale and Chord parameters are the same for all Sound slots in a particular Group, you
can have different Scale and Chord parameters for each Group. The Scale and Chord pa-
rameters of each Group are saved with the Project. However, when you save a Group the
Scale and Chord parameters are
not saved with the Group.
▪ The Scale and Chord engine processes live input from the pads of your controller only. In-
put from third-party MIDI controllers and data recorded in the Pattern Editor are not proc-
essed by the Scale and Chord engine.
KOMPLETE KONTROL S-SERIES owners: Input from your KOMPLETE KONTROL S-SERIES key-
board can also be processed by the Scale and Chord engine. This is described in section Using the
Perform Features.
▪ The output of the Scale and Chord engine is recorded into the Pattern Editor.
▪ The Scale and Chord parameters cannot be modulated nor automated in MASCHINE.
▪ Of course, if a Sound slot contains a KOMPLETE instrument providing control notes (e.g.,
key switches) on particular keys, these notes will not be triggered by the Scale and Chord
engine.
Available Scales
The Scale engine is controlled via two parameters:
▪ Root Note (C3 by default): Defines both the root note of the scale and the particular key
triggered by pad 1. As a direct consequence, pad 1 always triggers the root note of the se-
lected scale.
The Root Note parameter replaces the Base Key parameter found in the Keyboard mode of previous
MASCHINE versions and still available in Pad Mode. Although the Root Note is edited in the same
way as the Base Key on your controller, keep in mind that both are independent of each other. Com-
pared to the Base Key, the Root Note additionally defines the starting note of the selected scale.
Furthermore, like all Scale and Chord parameters, the Root Note is common to all Sound slots in
the Group, whereas the Base Key is set for each Sound slot independently.
Playing on the Controller
Performance Features
MASCHINE MIKRO - Manual - 241