Native Instruments MASCHINE MIKRO MK3 Groove Production Studio (Black) - Manual (Page 399)

10.1.2 Bass Synth Parameters
Available from the both the Control area of the Arrange view and in the Plug-in Strip of the Mix
view, the parameters are as follows:
The parameters described are presented as they appear in the Control area (Arrange view). The
same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
↑ 13.4,
The Plug-in Strip for more information on this.
Main Page
Element Description
OSC Section
Shape Adjusts the waveform shape continuously from sine to square. To
adjust the waveform shape, turn the Shape knob by clicking and
dragging upwards or downwards. The waveform shape can be
viewed in the Plug-in Strip of the Mix view.
Octave Transposes the base key of the Bass Synth (range: -3 – 3). To
transpose the base key, turn the
Octave knob by clicking and
dragging upwards or downwards.
Filter Section
Cutoff Adjusts the frequency of the low-pass filter (range: 14.6 Hz – 23.7
KHz). To adjust the cutoff frequency, turn the
Cutoff knob by
clicking and dragging upwards or downwards.
Resonance Adjusts the amount of boost around the cutoff frequency (range:
0.0% – 120%), Resonance can start to self-oscillate when
increasing the amount over 100.0 %. To adjust the amount of
resonance, turn the Resonance knob by clicking and dragging
upwards or downwards.
Envelope Section
Using the Bass Synth
Bass Synth – General Handling
MASCHINE MIKRO - Manual - 399