Adept AdeptSight Reference Guide - Manual (Page 482)

ToolPositionX
VPARAMETER
100
X coordinate of the center of the tool region of interest.
Figure: Illustration of the Tool position
Syntax
MicroV+
VPARAMETER (sequence_id, tool_id, 100, index_id, object_id) = value
value = VPARAMETER (sequence_id, tool_id, 100, index_id, object_id)
V+
VPARAMETER (sequence_id, tool_id, 100, index_id, object_id) $ip = value
value = VPARAMETER ($ip, sequence_id, tool_id, 100, index_id, object_id)
Type
Double
Range
Unbounded
Parameters
$ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP
ToolPositionX
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 482