Adept AdeptSight Reference Guide - Manual (Page 148)

DetailLevel
VPARAMETER
301
The coarseness of the contours at the Detail level. This property can only be set when ParametersBasedOn
is set to hsParametersCustom. Read only otherwise.
Syntax
MicroV+
VPARAMETER (sequence_id, tool_id, 301, index_id, object_id) = value
value = VPARAMETER (sequence_id, tool_id, 301, index_id, object_id)
V+
VPARAMETER (sequence_id, tool_id, 301, index_id, object_id) $ip = value
value = VPARAMETER ($ip, sequence_id, tool_id, 301, index_id, object_id)
Remarks
For most applications, the ParametersBasedOn property should be set to hsParametersAllModels.
Custom contour detection should only be used when the default values do not work correctly.
Type
Long
Range
Minimum: 1
Maximum: 16
Parameters
$ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP
address format, for example: 192.168.1.120.
sequence_id Index of the vision sequence. The first sequence is 1.
tool_id Index of the tool in the vision sequence. The first tool is 1.
DetailLevel
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 148