Adept AdeptSight Reference Guide - Manual (Page 457)

SequenceExecutionMode
VPARAMETER
10200
Sets the mode for execution of the sequence. When VRUN is called the sequence is run if single execution
mode is selected (0) or in continuously if continuous mode is selected.
Syntax
MicroV+
VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id) = value
value = VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id)
V+
VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id) $ip = value
value = VPARAMETER ($ip, sequence_id, tool_id, 10200, index_id, object_id)
Type
Long
Range
Value Execution Mode Description
0 Single execution Executes the vision sequence once.
1 Continuous mode
Executes the vision sequence continuously, until the execution is
stopped by a program instruction.
Parameters
sequence_id Index of the vision sequence. The first sequence is 1.
tool_id Should always be set to -1.
ID 10200: the value used to reference this property.
index_id N/A
SequenceExecutionMode
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 457