Loadrobotcalibration – Adept AdeptSight Reference Guide User Manual
Page 317
LoadRobotCalibration
VPARAMETER
10304
This command code is not directly supported in AdeptSight 3.x at this time. Please
contact Adept Technical Support for programming options.
Loads the selected robot calibration file to the selected robot device. The valid format for a robot calibration
file is hscal.
Remarks
Import calibrations into a vision project only if you are sure that this calibration is
valid.
Otherwise this may cause hazardous and unexpected behavior of devices in the
workcell, which may lead to equipment damage or bodily injury.
Type
Long
Example
See SaveSequence for an example of the syntax and the use of all Load and Save properties.
Related Topics
LoadRobotCalibration
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 317