Amer Networks E5Web GUI - Manual (Page 745)

value for some specific issues.
If cOS Core is upgraded, Dynamic High Buffers should be enabled since the memory
requirements of a new version may change and cOS Core should be allowed to allocate
the required memory automatically. Support personnel might still recommend using a
fixed value after the upgrade.
Max Connections
Packet re-assembly collects IP fragments into complete IP datagrams and, for TCP, reorders
segments so that they are processed in the correct order and also to keep track of potential
segment overlaps and to inform other subsystems of such overlaps. The associated settings limit
memory used by the re-assembly subsystem.
This setting specifies how many connections can use the re-assembly system at the same time. It
is expressed as a percentage of the total number of allowed connections. Minimum 1, Maximum
100.
Default: 80
Max Memory
This setting specifies how much memory that the re-assembly system can allocate to process
packets. It is expressed as a percentage of the total memory available. Minimum 1, Maximum
100.
Default: 3
Timeout
The time in seconds before cOS Core automatically enables its screen saver for a cOS Core
Software only installation. The screen saver will automatically adapt its activity to the current
CPU load of the system. During high loads, it will update once per second, consuming a fraction
of a percent of CPU load.
Default: 300 seconds (5 minutes)
Screen Saver Selection
The type of screen saver used.
Default: Blank
Status Bar Selection
The status bar control.
Default: Auto
Max Pipe Users
The maximum number of pipe users to allocate. As pipe users are only tracked for a 20th of a
second, this number usually does not need to be anywhere near the number of actual users, or
the number of statefully tracked connections. If there are no configured pipes, no pipe users will
Chapter 12: Advanced Settings
745