Amer Networks E5Web GUI - Manual (Page 625)

Follow the same steps used for the Web Interface below.
Web Interface
1. Go to: Policies > User Authentication User Authentication Rules > Add > UserAuthRule
2. Enter a suitable name for the rule, for example L2TP_Auth
3. Now enter:
• Agent: PPP
• Authentication Source: Local
• Interface: l2tp_tunnel
• Originator IP: all-nets
• Terminator IP: wan_ip
4. Under the Authentication Options tab enter UserDB as the Local User DB
5. Click OK
When the other parts are done, all that is left is the rules. To let traffic through from the tunnel,
two IP rules should be added.
E. Finally, set up the rules:
Command-Line Interface
Device:/> add IPRule action=Allow
Service=all_services
SourceInterface=l2tp_tunnel
SourceNetwork=l2tp_pool
DestinationInterface=any
DestinationNetwork=all-nets
name=AllowL2TP
Device:/main> add IPRule action=NAT
Service=all_services
SourceInterface=l2tp_tunnel
SourceNetwork=l2tp_pool
DestinationInterface=any
DestinationNetwork=all-nets
name=NATL2TP
InControl
Follow the same steps used for the Web Interface below.
Web Interface
1. Go to: Policies > Add > IPRule
2. Enter a name for the rule, for example AllowL2TP
3. Now enter:
Chapter 9: VPN
625